This organizer is was designed to take a set of batteries and their charger that use to take up far too much space on my workbench and neatly organize them mounted up on the wall. Pick yours up today to turn your own tangled mess into a neat and organized battery charging station.
Features:
- Holds 1 LCS436 charger and up to 3 batteries
- Mounts securely to wood or drywall with the included fasteners
- Compatible with Black and Decker 40V batteries up to 2 AH (I don't have any of the 3 AH batteries and would love to verify compatibility so please get in touch if you have one of these and are willing to measure it for me!)
- Designed and 3D printed by myself in the United States of America
- Created using a special heat resistant plastic (PETG / Co Polyester) that does not get damaged by heat and the sun in the same way that most 3D printed products do.
Package includes:
1 LCS436 Wall Mount Battery and Charger Organizer (3 Parts)
2 Drywall Fasteners
2 Wood Screws
3 Pieces of Wire Management Hook and Loop Tape
CHARGER AND BATTERIES ARE FOR DISPLAY PURPOSES ONLY AND ARE NOT INCLUDED
Instructions:
- Mount the organizer to the wall using the included wood screws or drywall fasteners.
- Slide your LCS436 battery charger up into the main body of the organizer
- Route the cord of the charger into the center of the organizer using the built in channel
- Secure the charger into place with the cross bar piece by inserting the tab on the main body into the slot on the crossbar and sliding it over
- Lock the cross bar into place using the included bolt and tighten with a coin or large screw driver
- Route the cord out of one of the wire management notches and tie it up neatly using the included hook and loop tape
- Load up the organizer with up to three batteries (one on the charger and two on the sides of the organizer) and enjoy your newly cleared workspace!
This organizer is was designed to take a set of batteries and their charger that use to take up far too much space on my workbench and neatly organize them mounted up on the wall. Pick yours up today to turn your own tangled mess into a neat and organized battery charging station.
Features:
- Holds 1 LCS436 charger and up to 3 batteries
- Mounts securely to wood or drywall with the included fasteners
- Compatible with Black and Decker 40V batteries up to 2 AH (I don't have any of the 3 AH batteries and would love to verify compatibility so please get in touch if you have one of these and are willing to measure it for me!)
- Designed and 3D printed by myself in the United States of America
- Created using a special heat resistant plastic (PETG / Co Polyester) that does not get damaged by heat and the sun in the same way that most 3D printed products do.
Package includes:
1 LCS436 Wall Mount Battery and Charger Organizer (3 Parts)
2 Drywall Fasteners
2 Wood Screws
3 Pieces of Wire Management Hook and Loop Tape
CHARGER AND BATTERIES ARE FOR DISPLAY PURPOSES ONLY AND ARE NOT INCLUDED
Instructions:
- Mount the organizer to the wall using the included wood screws or drywall fasteners.
- Slide your LCS436 battery charger up into the main body of the organizer
- Route the cord of the charger into the center of the organizer using the built in channel
- Secure the charger into place with the cross bar piece by inserting the tab on the main body into the slot on the crossbar and sliding it over
- Lock the cross bar into place using the included bolt and tighten with a coin or large screw driver
- Route the cord out of one of the wire management notches and tie it up neatly using the included hook and loop tape
- Load up the organizer with up to three batteries (one on the charger and two on the sides of the organizer) and enjoy your newly cleared workspace!
